In the use of UV light oil should pay attention to the following points-Iota

Products

News

Office Address:	Sunmoon Science Park, 985 Xingzhong Road, High-Tech Zone, Bengbu, China
Factory Address:	Mohekou Industrial Park, Huaishang District, Bengbu, Anhui, China
Contact:	Ariel Young
Phone:	0086-552-3827158
FAX:	0086-552-3822922
Mobile:	0086-15255290433
WebSite:	www.siliconeoil.cn www.siliconeoil.net
Email:	sales@siliconeoil.net
QQ:

Service > In the use of UV light oil should pay attention to the following points

In the use of UV light oil should pay attention to the following points

(1) the normal use of UV light oil temperature is 50-55 DEG C, the low temperature in winter when using the need of isothermal waters cyclic heating of the UV light oil, the viscosity reaches the design viscosity, so that is conducive to UV light oil flow and fast curing.
(2) the UV light oil after UV light irradiation area, the optimum temperature is 50-60 DEG C, because at this temperature UV light oil curing fast, after curing, strong adhesive force. That is to say, in UV under the light does not lower the temperature. Some manufacturers in the low temperature in winter workshop glazing, appear poor adhesion, leveling is not good, the main reason lies in the.
(3) the glazing machine should be placed in the sun can not directly irradiate the position, or the action of ultraviolet light UV light oil will be in the sun cured under the coating roller. If you can't avoid direct sunlight, should also be used red curtains block the sun's rays.
(4) the UV varnish glazing is scraped away will have been printed on material and ink to UV light oil machine on the glazing oil, make a color. However, after filtration after precipitation, the light oil can continue to use, do not have to throw away.
(5) with the development of science and technology, the current stimulation of UV varnish has been greatly reduced. But the Polish operation, the skin if encounter UV light oil, or immediately with soap and water wash, otherwise there may be skin redness and swelling, blistering.
(6) the use of UV light oil viscosity depends on types of polishing machine, polishing machine models according to the selection of special polishing oil. If the UV light oil viscosity is not up to the machine need viscosity use thinner anti stick or with a thickening agent and stick. But after this regulation after loss of UV light oil curing speed, brightness and adhesion etc..
(7) the UV light oil flow to the rotating part machine transmission shaft, at high temperatures will stick on the transmission shaft, affect the transmission. Therefore should pay attention to cleaning head.
(8) the gold card paper, PFT and other special printing materials according to their surface properties, select the special UV glazing oil.

Feedback to "Iota Silicone Oil (Anhui) Co., Ltd."