How to properly use a release agent-Iota

Products

News

Office Address:	Sunmoon Science Park, 985 Xingzhong Road, High-Tech Zone, Bengbu, China
Factory Address:	Mohekou Industrial Park, Huaishang District, Bengbu, Anhui, China
Contact:	Nathan Zhang
Phone:	0086-552-19805521900
FAX:	0086-552-3822922
Mobile:	19805521900/18119733779
WebSite:	www.siliconeoil.cn www.siliconeoil.net
Email:
QQ:	729118868

News > Dynamic industry > How to properly use a release agent

How to properly use a release agent

Release agent used is a rubber processing aid, the main role is to prevent material bonded to each other. To pay attention to the following aspects of the use of a release agent:
1, the general use of stainless steel mold with a release agent to use, and recommended hot film would be better.
2. Before using a new mold, the best first empty baking mold 2-3 times, the benefits of doing so one can burn the butter, you can also make the mold expansion coefficient stability. When using the old abrasive, remember to remove surface dust, otherwise it will affect the results.
3, the release agent is not bad, it can be reused. When found less effective, you can use reinforcing some,, after release agents, mold temporarily if not, should die alone put legislation, avoid superposition dirty mold. Mold place some time to re-use, it should be cleaned of impurities, put the glass once again try grilled use.
4, although the release agent can reach a maximum temperature of 1200 ℃, but must also pay attention when packing in fire-proof.
Limited to provide you with more information by Laiyang.

分享到

Feedback to "Iota Silicone Oil (Anhui) Co., Ltd."