How to detect the decoration effect?-Iota

Products

News

Office Address:	Sunmoon Science Park, 985 Xingzhong Road, High-Tech Zone, Bengbu, China
Factory Address:	Mohekou Industrial Park, Huaishang District, Bengbu, Anhui, China
Contact:	Nathan Zhang
Phone:	0086-552-19805521900
FAX:	0086-552-3822922
Mobile:	19805521900/18119733779
WebSite:	www.siliconeoil.cn www.siliconeoil.net
Email:
QQ:	729118868

How to detect the decoration effect?

First, pipe detection. The location of discharge pipes, should be based on the nearest distance at least for the standard interface, the pipe body is neat, withoutoverlapping and bending. The indoor brass, PVC water use, use the hot waterbag plastic copper pipe, interface to use waterproof tape. Installation and sometimes sit face to the level and four are. The installation leading or cover with cloth tools, not ruin hydrants and accessories, not used directly Tiechui vigorously percussion. The kitchen, toilet to leak. The installed to test water.

Second, the floor detection. The floor should be smooth, no pits and scratches,corner to burnish machine burnish. Second, at least for the floor coating three times. The laying of quadrilateral reserved mm space, and then use the line Fengbian feet covered. The wood floor to use splint do bottom, bottom to put agreaseproof paper or plastic film, and quadrilateral reserved space.

Third, tile detection. The point to be accurate, brick to embed Ping, interface to the line. The ceramic tile in the use of the former inundate half day. The toilet floor to have the appropriate slope, water can not be. And white cement after theceramic tile interface use can brush clean and white cement, can not be left in the brick surface cement stains. The paving slabs after use cardboard, covered with brick surface, and at least 2 hours before the brick surface running.

Fourth, paint detection. The surface color should be correct, uniform, bright and smooth, no tears, too thick, the end, bubble conditions. The latex paint in metersfrom the point of view, should not see and mark. The walls Pihui not bumpconcave, corner of a wall formation. The board and the wall plate and the plate,interface, should be posted on the tape after pihui. The painting border flattened were out of bounds, not oil. The peg coloring to accurate, smooth; the try not tobrush paint in wet weather.

Fifth, wood detection. The wooden plate surface smooth, no burrs, text clear,consistent color, straight seams founder. To be bonded firmly, surface clean, no excess glue, floor block arrangement reasonable and beautiful. The gap is tight,tight joints, the joint arrangement of a reasonable appearance, Kamiguchi Hirano,accurate cutting angle. The hot hard wood floor wax, rub the soft wax have to not even open at the end, smooth and bright, color consistency.

Jiezhuang detection can not ignore oh! Be sure to check especially in thedecoration company installed turnover, if not understand, we must find an experienced friend to help have a look of the decoration, it can be done away with a lot of unnecessary trouble.